Technical information about motor feeder

First, the purpose and features:
BZG series of ordinary motor-driven inertial vibration feeder is learned at GZG series , GZY series vibrating feeder advantages of other models developed . This machine is an

ideal feeder high efficiency and low noise , low double roller crusher frequency high amplitude vibration , large capacity . Used in mining , metallurgy,

Chemicals, building materials and other industries a variety of bulk materials transportation , but also for high moisture , content of large viscous materials.
Second, the working principle and structure characteristics:
The series feeder feeding process is the use apron feeder of special vibration motor or two motor driven exciter driven feed chute for an oblique direction to achieve linear vibration cycle

, when the feeding trough is greater than the vertical component of the acceleration of the vibration acceleration of gravity when the tank material was tossed

And in accordance with the parabolic trajectory jump forward movement , toss and whereabouts in an instant , as the excitation source, continuous excitation , feeding trough

continuous vibration , continuous coal tank jump forward in order to achieve the purpose of feeding .

Six , installation and commissioning
1 , the product is installed into sitting and hanging installation. Can be used as normal feeding -10 ° installation , viscous or high moisture content of the material can be

-15 ° installation. But for ingredients or dosing , in order to ensure the feeding accuracy , we recommend horizontal installation .
2 , in order to ensure the normal operation of the feeder , hopper should minimize the effects of stress , the proposed device is used to configure the appropriate slip mouth.
3, to the trough and the upper seal cover, side brackets , which are not part of the vibration should be greater than the distance between objects 50mm. Should be aligned with

the axis of the corresponding two motors rotating shaft vibrator .
4 , Block feeder installed before the first on-site infrastructure and feeder installation diagram control , inspection, embedded steel , steel plate thickness of 20mm, the

flatness of less than 1.5 ‰ mm.
5 , feeder installed, adjust the relative position of the axis of the motor should be lower than the exciter axis 2-3mm. Four damping spring compression shall not exceed ± 3mm,

after adjusting the spring bearing , motor bracket with embedded steel fastening or welding firm.
6 , two feeder motor rotation must be reversed.
7, the installation is complete run 2-4 hours , the body running smoothly, yaw is not greater than 0.5mm, no abnormal noise , the direction of the fastening bolts into use .
8 , in use, if the processing capacity is not enough, in permitting , you can adjust the size of the exciter excitation force , in order to achieve the best results .
Exciting force adjustments:
a. Remove the protective cover
b. would loosen the two outer eccentric
c. the same phase , with the angle of adjustment both outer eccentric biased
d. Tighten adjustment bolt , fitted with protective cover
Maintenance:
a. feeder in the work process , should pay attention to the tank movement is stable , if found not functioning properly or have unusual sounds , immediately stop checking.
b. shakers filling once a month 3 # lithium grease , bearing should be checked cleaned once a year , check to see the degree of wear of bearings , if necessary, the timely

replacement of repair.
c. should always check the connection parts of the fastening bolt is loose, should be promptly eliminate hidden dangers.