Feeder in the crushing production line should pay attention to the problems

Vibrating feeder is widely used in metallurgy , mineral processing , building materials , chemicals, abrasive and other industries crushing, screening , you can put granular

bulk materials from silos timed , evenly and continuously into the affected device to go to prevent the affected device because of uneven Pan feeder produced crash phenomenon ,

Prolong the life of the crusher device .
Installation choices :
a. horizontal installation , uniform and stable material for general feeding situation prevents material gravity ;
b. downward 10 °, applicable to the general case of continuous Feeding equipment of materials ;
c. downward 15 °, for viscous or high moisture material continuous feeding situation.
Precautions before and after running :
All bolts should be tightened before running again , especially the vibration motor bolts , 3-5 hours of continuous operation should be re- tightened once ; run two vibrating

motors must reverse rotation. If the current is unstable or that there is no noise was very loud , they should immediately stop treatment .
Feeder should be how to maintain
First, due to the vibration of the motor current and motor surface temperature requirements before and after amplitude uniform, do not shake swing around , so always check the

amplitude of the vibration motor , such as abnormal situation should be shut down immediately ;
Second, the motor bearing maintenance is also very important. Motor bearings crushing production line is the feeder nozzle of key equipment, generally once every two months

filling oil , hot season once every month to raise oil . Every six months to be re- motor overhaul once inside

Ministry bearings should be replaced.